[PATCH 5/5] dts: r64: add sata- and asm_sel nodes

Frank Wunderlich linux at fw-web.de
Mon Aug 10 16:58:51 CEST 2020


From: Frank Wunderlich <frank-w at public-files.de>

asm_sel is for switching between sata and pcie mode
on r64 there is GPIO90 connected to ASM1480 which
switches RX/TX pairs to PCIe/SATA connector
output-low means sata-controller is active

with 2020-10 now reg is also needed for the phy itself

Signed-off-by: Frank Wunderlich <frank-w at public-files.de>
---
 arch/arm/dts/mt7622-bpi-r64.dts |  9 +++++++
 arch/arm/dts/mt7622.dtsi        | 44 +++++++++++++++++++++++++++++++++
 2 files changed, 53 insertions(+)

diff --git a/arch/arm/dts/mt7622-bpi-r64.dts b/arch/arm/dts/mt7622-bpi-r64.dts
index c89e816878..51287cea3a 100644
--- a/arch/arm/dts/mt7622-bpi-r64.dts
+++ b/arch/arm/dts/mt7622-bpi-r64.dts
@@ -235,3 +235,12 @@
 		full-duplex;
 	};
 };
+
+&gpio {
+	/*gpio 90 for setting mode to sata*/
+	asm_sel {
+		gpio-hog;
+		gpios = <90 GPIO_ACTIVE_HIGH>;
+		output-low;
+	};
+};
diff --git a/arch/arm/dts/mt7622.dtsi b/arch/arm/dts/mt7622.dtsi
index fec071643e..2802909671 100644
--- a/arch/arm/dts/mt7622.dtsi
+++ b/arch/arm/dts/mt7622.dtsi
@@ -10,6 +10,7 @@
 #include <dt-bindings/power/mt7629-power.h>
 #include <dt-bindings/reset/mt7629-reset.h>
 #include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/phy/phy.h>
 
 / {
 	compatible = "mediatek,mt7622";
@@ -270,6 +271,49 @@
 		};
 	};
 
+	sata: sata at 1a200000 {
+		compatible = "mediatek,mtk-ahci";
+//		reg = <0 0x1a200000 0 0x1100>;
+		reg = <0x1a200000 0x1100>;
+		resets = <&pciesys MT7622_SATA_AXI_BUS_RST>,
+			<&pciesys MT7622_SATA_PHY_SW_RST>,
+			<&pciesys MT7622_SATA_PHY_REG_RST>;
+		reset-names = "axi", "sw", "reg";
+		mediatek,phy-mode = <&pciesys>;
+		ports-implemented = <0x1>;
+/*
+		interrupts = <GIC_SPI 233 IRQ_TYPE_LEVEL_HIGH>;
+		interrupt-names = "hostc";
+		clocks = <&pciesys CLK_SATA_AHB_EN>,
+			<&pciesys CLK_SATA_AXI_EN>,
+			<&pciesys CLK_SATA_ASIC_EN>,
+			<&pciesys CLK_SATA_RBC_EN>,
+			<&pciesys CLK_SATA_PM_EN>;
+			clock-names = "ahb", "axi", "asic", "rbc", "pm";
+		power-domains = <&scpsys MT7622_POWER_DOMAIN_HIF0>;
+		status = "disabled";*/
+		phys = <&sata_port PHY_TYPE_SATA>;
+		phy-names = "sata-phy";
+		status = "okay";
+	};
+
+	sata_phy: sata-phy at 1a243000 {
+		compatible = "mediatek,generic-tphy-v1";
+		reg = <0x1a243000 0x0100>;
+		#address-cells = <1>;
+		#size-cells = <1>;
+		ranges;
+		status = "okay";
+
+		sata_port: sata-phy at 1a243000 {
+			reg = <0x1a243000 0x0100>;
+			clocks = <&topckgen CLK_TOP_ETH_500M>;
+			clock-names = "ref";
+			#phy-cells = <1>;
+			status = "okay";
+		};
+	};
+
 	ethsys: syscon at 1b000000 {
 		compatible = "mediatek,mt7622-ethsys", "syscon";
 		reg = <0x1b000000 0x1000>;
-- 
2.25.1



More information about the U-Boot mailing list