[Uboot-stm32] [PATCH] board: stm32mp1: remove board.c

[Patrice CHOTARD]

Hi Patrick

On 7/30/20 1:57 PM, Patrick Delaunay wrote:
> Remove the file board/st/stm32mp1/board.c which is not more
> compiled since commit 156732cc8939 ("board: stm32mp1: move the
> function board_debug_uart_init in spl.c")
>
> Fixes: 156732cc8939 ("board: stm32mp1: move the function board_debug_uart_init in spl.c")
> Signed-off-by: Patrick Delaunay <patrick.delaunay at st.com>
> ---
> Issue when initial patch [1] was applied:
>
> diff --git a/board/st/stm32mp1/board.c b/board/st/stm32mp1/board.c
> deleted file mode 100644
>
> [1] http://patchwork.ozlabs.org/project/uboot/patch/20200525101949.15944-10-patrick.delaunay@st.com/
>
>
>  board/st/stm32mp1/board.c | 36 ------------------------------------
>  1 file changed, 36 deletions(-)
>  delete mode 100644 board/st/stm32mp1/board.c
>
> diff --git a/board/st/stm32mp1/board.c b/board/st/stm32mp1/board.c
> deleted file mode 100644
> index 00c61c2886..0000000000
> --- a/board/st/stm32mp1/board.c
> +++ /dev/null
> @@ -1,36 +0,0 @@
> -// SPDX-License-Identifier: GPL-2.0+ OR BSD-3-Clause
> -/*
> - * Copyright (C) 2018, STMicroelectronics - All Rights Reserved
> - */
> -
> -#include <common.h>
> -#include <asm/io.h>
> -#include <linux/bitops.h>
> -#include <linux/delay.h>
> -
> -#ifdef CONFIG_DEBUG_UART_BOARD_INIT
> -void board_debug_uart_init(void)
> -{
> -#if (CONFIG_DEBUG_UART_BASE == STM32_UART4_BASE)
> -
> -#define RCC_MP_APB1ENSETR (STM32_RCC_BASE + 0x0A00)
> -#define RCC_MP_AHB4ENSETR (STM32_RCC_BASE + 0x0A28)
> -
> -	/* UART4 clock enable */
> -	setbits_le32(RCC_MP_APB1ENSETR, BIT(16));
> -
> -#define GPIOG_BASE 0x50008000
> -	/* GPIOG clock enable */
> -	writel(BIT(6), RCC_MP_AHB4ENSETR);
> -	/* GPIO configuration for EVAL board
> -	 * => Uart4 TX = G11
> -	 */
> -	writel(0xffbfffff, GPIOG_BASE + 0x00);
> -	writel(0x00006000, GPIOG_BASE + 0x24);
> -#else
> -
> -#error("CONFIG_DEBUG_UART_BASE: not supported value")
> -
> -#endif
> -}
> -#endif

Reviewed-by: Patrice Chotard <patrice.chotard at st.com>

Thanks

Patrice