[PATCH v2 6/7] riscv: Update Kendryte device tree for new CLINT driver
Bin Meng
bmeng.cn at gmail.com
Thu Aug 20 09:45:53 CEST 2020
On Wed, Jul 29, 2020 at 5:57 PM Sean Anderson <seanga2 at gmail.com> wrote:
>
> AFAIK because the K210 clock driver does not come up until after
> relocation, the clint will always use the clock-frequency parameter.
> Ideally, it should update itself after relocation to take into account the
> actual CPU frequency.
>
> Signed-off-by: Sean Anderson <seanga2 at gmail.com>
> ---
>
> Changes in v2:
> - New
>
> arch/riscv/dts/k210.dtsi | 9 ++++++---
> 1 file changed, 6 insertions(+), 3 deletions(-)
>
> diff --git a/arch/riscv/dts/k210.dtsi b/arch/riscv/dts/k210.dtsi
> index 2546c7d4e0..2698a33a5c 100644
> --- a/arch/riscv/dts/k210.dtsi
> +++ b/arch/riscv/dts/k210.dtsi
> @@ -17,6 +17,8 @@
> compatible = "kendryte,k210";
>
> aliases {
> + cpu0 = &cpu0;
> + cpu1 = &cpu1;
> dma0 = &dmac0;
> gpio0 = &gpio0;
> gpio1 = &gpio1_0;
> @@ -126,14 +128,15 @@
> read-only;
> };
>
> - clint0: interrupt-controller at 2000000 {
> + clint0: clint at 2000000 {
> #interrupt-cells = <1>;
> compatible = "kendryte,k210-clint", "riscv,clint0";
> reg = <0x2000000 0xC000>;
> - interrupt-controller;
Why is this property dropped?
> interrupts-extended = <&cpu0_intc 3>, <&cpu0_intc 7>,
> <&cpu1_intc 3>, <&cpu1_intc 7>;
> - clocks = <&sysclk K210_CLK_CPU>;
> + clocks = <&sysclk K210_CLK_CLINT>;
> + /* sysclk is only available post-relocation */
> + clock-frequency = <7800000>;
> };
>
> plic0: interrupt-controller at C000000 {
> --
Regards,
Bin
More information about the U-Boot
mailing list