[PATCH 0/2] omap4: panda: convert to device model

[Lokesh Vutla]

Hi Tero,

On 02/06/20 4:49 pm, Tero Kristo wrote:
> Hi,
> 
> As there is looming death to OMAP4 Panda board u-boot support, I decided
> to take a shot and convert it to device model myself. With these patches
> it boots up fine, and there are no DM_SPL conversion complaints during
> compile time anymore. I think USB ethernet does not work anymore with
> this, but its better than dropping the support for the board completely.
> USB itself appears working, so it should be relatively easy for someone
> to fix the networking support if they need it.

I see the below warning with these patches:

board/ti/panda/panda.c:329:35: warning: ‘struct ehci_hcor’ declared inside parameter list will not be visible outside of this definition or declaration
  329 |   struct ehci_hccr **hccr, struct ehci_hcor **hcor)
      |                                   ^~~~~~~~~
board/ti/panda/panda.c:329:10: warning: ‘struct ehci_hccr’ declared inside parameter list will not be visible outside of this definition or declaration
  329 |   struct ehci_hccr **hccr, struct ehci_hcor **hcor)
      |          ^~~~~~~~~
board/ti/panda/panda.c: In function ‘ehci_hcd_init’:
board/ti/panda/panda.c:339:8: warning: implicit declaration of function ‘omap_ehci_hcd_init’; did you mean ‘ehci_hcd_init’? [-Wimplicit-function-declaration]
  339 |  ret = omap_ehci_hcd_init(index, &usbhs_bdata, hccr, hcor);
      |        ^~~~~~~~~~~~~~~~~~
      |        ehci_hcd_init
board/ti/panda/panda.c: In function ‘ehci_hcd_stop’:
board/ti/panda/panda.c:348:9: warning: implicit declaration of function ‘omap_ehci_hcd_stop’; did you mean ‘ehci_hcd_stop’? [-Wimplicit-function-declaration]
  348 |  return omap_ehci_hcd_stop();
      |         ^~~~~~~~~~~~~~~~~~
      |         ehci_hcd_stop


Thanks and regards,
Lokesh


> 
> -Tero
> 
> 
> --
> Texas Instruments Finland Oy, Porkkalankatu 22, 00180 Helsinki. Y-tunnus/Business ID: 0615521-4. Kotipaikka/Domicile: Helsinki
>