Re: [PATCH v2 1/6] rock-pi-4: Enable USB3 Host【请注意,邮件由linux-rockchip-bounces+kever.yang=rock-chips.com at lists.infradead.org代发】

Kever Yang kever.yang at rock-chips.com
Sat Jun 27 16:37:12 CEST 2020


On 2020/6/18 下午10:12, Jagan Teki wrote:
> Enable USB3.0 Host support for RockPI-4 boards.
>
> Note that the Upper USB3.0 port is marked as otg and
> lower USB3.0 port marked as host, so this below log
> capture when USB3.0 mass storage plug in at lower
> USB 3.0 port.
>
> Log:
> Bus usb at fe380000: USB EHCI 1.00
> Bus usb at fe3c0000: USB EHCI 1.00
> Bus dwc3: usb maximum-speed not found
> Register 2000140 NbrPorts 2
> Starting the controller
> USB XHCI 1.10
> Bus dwc3: usb maximum-speed not found
> Register 2000140 NbrPorts 2
> Starting the controller
> USB XHCI 1.10
> scanning bus usb at fe380000 for devices... 1 USB Device(s) found
> scanning bus usb at fe3c0000 for devices... 1 USB Device(s) found
> scanning bus dwc3 for devices... 1 USB Device(s) found
> scanning bus dwc3 for devices... cannot reset port 1!?
> 2 USB Device(s) found
>         scanning usb for storage devices... 1 Storage Device(s) found
> => usb tree
> USB device tree:
>    1  Hub (480 Mb/s, 0mA)
>       u-boot EHCI Host Controller
>
>    1  Hub (480 Mb/s, 0mA)
>       u-boot EHCI Host Controller
>
>    1  Hub (5 Gb/s, 0mA)
>       U-Boot XHCI Host Controller
>
>    1  Hub (5 Gb/s, 0mA)
>    |  U-Boot XHCI Host Controller
>    |
>    +-2  Mass Storage (5 Gb/s, 224mA)
>         SanDisk Dual Drive 040130e3ee554b7078843f4eb331646
>
> Cc: Tom Cubie <tom at radxa.com>
> Signed-off-by: Jagan Teki <jagan at amarulasolutions.com>

Reviewed-by: Kever Yang <kever.yang at rock-chips.com>

Thanks,
- Kever
> ---
> Changes for v2:
> - rebase on master
>
>   configs/rock-pi-4-rk3399_defconfig | 6 ++++++
>   1 file changed, 6 insertions(+)
>
> diff --git a/configs/rock-pi-4-rk3399_defconfig b/configs/rock-pi-4-rk3399_defconfig
> index 0d86fdc895..2487872219 100644
> --- a/configs/rock-pi-4-rk3399_defconfig
> +++ b/configs/rock-pi-4-rk3399_defconfig
> @@ -28,6 +28,7 @@ CONFIG_ENV_IS_IN_MMC=y
>   CONFIG_SYS_RELOC_GD_ENV_ADDR=y
>   CONFIG_ROCKCHIP_GPIO=y
>   CONFIG_SYS_I2C_ROCKCHIP=y
> +CONFIG_MISC=y
>   CONFIG_MMC_DW=y
>   CONFIG_MMC_DW_ROCKCHIP=y
>   CONFIG_MMC_SDHCI=y
> @@ -35,11 +36,14 @@ CONFIG_MMC_SDHCI_ROCKCHIP=y
>   CONFIG_DM_ETH=y
>   CONFIG_ETH_DESIGNWARE=y
>   CONFIG_GMAC_ROCKCHIP=y
> +CONFIG_PHY_ROCKCHIP_INNO_USB2=y
> +CONFIG_PHY_ROCKCHIP_TYPEC=y
>   CONFIG_PMIC_RK8XX=y
>   CONFIG_REGULATOR_PWM=y
>   CONFIG_REGULATOR_RK8XX=y
>   CONFIG_PWM_ROCKCHIP=y
>   CONFIG_RAM_RK3399_LPDDR4=y
> +CONFIG_DM_RESET=y
>   CONFIG_BAUDRATE=1500000
>   CONFIG_DEBUG_UART_SHIFT=2
>   CONFIG_SYSRESET=y
> @@ -48,6 +52,8 @@ CONFIG_USB_XHCI_HCD=y
>   CONFIG_USB_XHCI_DWC3=y
>   CONFIG_USB_EHCI_HCD=y
>   CONFIG_USB_EHCI_GENERIC=y
> +CONFIG_USB_DWC3=y
> +CONFIG_USB_DWC3_GENERIC=y
>   CONFIG_USB_HOST_ETHER=y
>   CONFIG_USB_ETHER_ASIX=y
>   CONFIG_USB_ETHER_ASIX88179=y




More information about the U-Boot mailing list