[PATCH V2] ARM: socfpga: Add initial support for the ABB SECU board

[Marek Vasut]

On 2/19/20 7:55 PM, Marek Vasut wrote:
> From: Holger Brunck <holger.brunck at ch.abb.com>
> 
> Add initial support for the ABB SECU board, which is an ArriaV-based
> SoCFPGA system with ethernet and booting from Denali NAND.
> 
> Signed-off-by: Holger Brunck <holger.brunck at ch.abb.com>
> Cc: Ley Foon Tan <ley.foon.tan at intel.com>
> Cc: Simon Goldschmidt <simon.k.r.goldschmidt at gmail.com>
> ---
> V2: Use CONFIG_SYS_I2C_EEPROM_ADDR in printf() in ivm.c
>     Enable CONFIG_SYS_NAND_USE_FLASH_BBT
> ---
>  arch/arm/dts/Makefile                   |   1 +
>  arch/arm/dts/socfpga_arria5_secu1.dts   | 130 +++++
>  arch/arm/mach-socfpga/Kconfig           |  10 +
>  board/keymile/Kconfig                   |  11 +-
>  board/keymile/common/ivm.c              |  19 +-
>  board/keymile/secu1/Makefile            |   7 +
>  board/keymile/secu1/qts/iocsr_config.h  | 694 ++++++++++++++++++++++++
>  board/keymile/secu1/qts/pinmux_config.h | 218 ++++++++
>  board/keymile/secu1/qts/pll_config.h    |  83 +++
>  board/keymile/secu1/qts/sdram_config.h  | 327 +++++++++++
>  board/keymile/secu1/socfpga.c           |  67 +++
>  configs/socfpga_secu1_defconfig         |  84 +++
>  include/configs/socfpga_arria5_secu1.h  | 131 +++++

So, this is missing MAINTAINERS file. I will just manually add it:

$ cat board/keymile/secu1/MAINTAINERS
ABB SECU1 BOARD
M:      Holger Brunck <holger.brunck at ch.abb.com>
S:      Maintained
F:      include/configs/socfpga_arria5_secu1.h
F:      configs/socfpga_secu1_defconfig

is that OK ?