[PATCH V2] ARM: socfpga: Add initial support for the ABB SECU board

[Holger Brunck]

> On 2/19/20 7:55 PM, Marek Vasut wrote:
> > From: Holger Brunck <holger.brunck at ch.abb.com>
> >
> > Add initial support for the ABB SECU board, which is an ArriaV-based
> > SoCFPGA system with ethernet and booting from Denali NAND.
> >
> > Signed-off-by: Holger Brunck <holger.brunck at ch.abb.com>
> > Cc: Ley Foon Tan <ley.foon.tan at intel.com>
> > Cc: Simon Goldschmidt <simon.k.r.goldschmidt at gmail.com>
> > ---
> > V2: Use CONFIG_SYS_I2C_EEPROM_ADDR in printf() in ivm.c
> >     Enable CONFIG_SYS_NAND_USE_FLASH_BBT
> > ---
> >  arch/arm/dts/Makefile                   |   1 +
> >  arch/arm/dts/socfpga_arria5_secu1.dts   | 130 +++++
> >  arch/arm/mach-socfpga/Kconfig           |  10 +
> >  board/keymile/Kconfig                   |  11 +-
> >  board/keymile/common/ivm.c              |  19 +-
> >  board/keymile/secu1/Makefile            |   7 +
> >  board/keymile/secu1/qts/iocsr_config.h  | 694
> > ++++++++++++++++++++++++  board/keymile/secu1/qts/pinmux_config.h |
> 218 ++++++++
> >  board/keymile/secu1/qts/pll_config.h    |  83 +++
> >  board/keymile/secu1/qts/sdram_config.h  | 327 +++++++++++
> >  board/keymile/secu1/socfpga.c           |  67 +++
> >  configs/socfpga_secu1_defconfig         |  84 +++
> >  include/configs/socfpga_arria5_secu1.h  | 131 +++++
> 
> So, this is missing MAINTAINERS file. I will just manually add it:
> 
> $ cat board/keymile/secu1/MAINTAINERS
> ABB SECU1 BOARD
> M:      Holger Brunck <holger.brunck at ch.abb.com>
> S:      Maintained
> F:      include/configs/socfpga_arria5_secu1.h
> F:      configs/socfpga_secu1_defconfig
> 
> is that OK ?

yes, thank you.

Best regards
Holger