[PATCH v8 17/21] sifive: fu540: Add U-Boot proper sector start

Pragnesh Patel pragnesh.patel at sifive.com
Sat May 9 16:30:32 CEST 2020


From: Jagan Teki <jagan at amarulasolutions.com>

Add U-Boot proper sector start offset for SiFive FU540.
This value is based on the partition layout supported
by SiFive FU540.

u-boot.itb need to write on this specific offset so-that
the SPL will retrieve it from here and load.

Signed-off-by: Jagan Teki <jagan at amarulasolutions.com>
Reviewed-by: Bin Meng <bmeng.cn at gmail.com>
Reviewed-by: Pragnesh Patel <pragnesh.patel at sifive.com>
---
 common/spl/Kconfig | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/common/spl/Kconfig b/common/spl/Kconfig
index 9feadb5e43..9d6f51d672 100644
--- a/common/spl/Kconfig
+++ b/common/spl/Kconfig
@@ -308,7 +308,7 @@ config SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR
 		     ARCH_MX6 || ARCH_MX7 || \
 		     ARCH_ROCKCHIP || ARCH_MVEBU ||  ARCH_SOCFPGA || \
 		     ARCH_AT91 || ARCH_ZYNQ || ARCH_KEYSTONE || OMAP34XX || \
-		     OMAP44XX || OMAP54XX || AM33XX || AM43XX
+		     OMAP44XX || OMAP54XX || AM33XX || AM43XX || TARGET_SIFIVE_FU540
 	help
 	  Use sector number for specifying U-Boot location on MMC/SD in
 	  raw mode.
@@ -325,6 +325,7 @@ config SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR
 	default 0x300 if ARCH_ZYNQ || ARCH_KEYSTONE || OMAP34XX || OMAP44XX || \
 		         OMAP54XX || AM33XX || AM43XX || ARCH_K3
 	default 0x4000 if ARCH_ROCKCHIP
+	default 0x822 if TARGET_SIFIVE_FU540
 	help
 	  Address on the MMC to load U-Boot from, when the MMC is being used
 	  in raw mode. Units: MMC sectors (1 sector = 512 bytes).
-- 
2.17.1



More information about the U-Boot mailing list