[PATCH 20/26] arm: mach-k3: do board config for PM and RM only if supported

[Tero Kristo]

If the raw PM support is built in, we are operating in the split
firmware approach mode where RM and PM support is not available. In this
case, skip the board config for these two.

Signed-off-by: Tero Kristo <t-kristo at ti.com>
---
 arch/arm/mach-k3/sysfw-loader.c | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/arch/arm/mach-k3/sysfw-loader.c b/arch/arm/mach-k3/sysfw-loader.c
index 78c158c63f..154d2df049 100644
--- a/arch/arm/mach-k3/sysfw-loader.c
+++ b/arch/arm/mach-k3/sysfw-loader.c
@@ -158,11 +158,13 @@ static void k3_sysfw_configure_using_fit(void *fit,
 		      ret);
 
 	/* Apply power/clock (PM) specific configuration to SYSFW */
+#ifdef CONFIG_CLK_TI_SCI
 	ret = board_ops->board_config_pm(ti_sci,
 					 (u64)(u32)cfg_fragment_addr,
 					 (u32)cfg_fragment_size);
 	if (ret)
 		panic("Failed to set board PM configuration (%d)\n", ret);
+#endif
 
 	/* Extract resource management (RM) specific configuration from FIT */
 	ret = fit_get_data_by_name(fit, images, SYSFW_CFG_RM,
@@ -171,12 +173,14 @@ static void k3_sysfw_configure_using_fit(void *fit,
 		panic("Error accessing %s node in FIT (%d)\n", SYSFW_CFG_RM,
 		      ret);
 
+#ifdef CONFIG_CLK_TI_SCI
 	/* Apply resource management (RM) configuration to SYSFW */
 	ret = board_ops->board_config_rm(ti_sci,
 					 (u64)(u32)cfg_fragment_addr,
 					 (u32)cfg_fragment_size);
 	if (ret)
 		panic("Failed to set board RM configuration (%d)\n", ret);
+#endif
 
 	/* Extract security specific configuration from FIT */
 	ret = fit_get_data_by_name(fit, images, SYSFW_CFG_SEC,
-- 
2.17.1

--
Texas Instruments Finland Oy, Porkkalankatu 22, 00180 Helsinki. Y-tunnus/Business ID: 0615521-4. Kotipaikka/Domicile: Helsinki