[PATCH v4 0/7] wdt: Add support for watchdogs on Kendryte K210

Sean Anderson seanga2 at gmail.com
Thu Oct 1 16:56:30 CEST 2020


On 9/9/20 5:04 PM, Sean Anderson wrote:
> This series depends on
> https://patchwork.ozlabs.org/project/uboot/list/?series=200642
> 
> Changes in v4:
> - Fix build error without CONFIG_CLK
> 
> Changes in v3:
> - Note dependency on "time: Fix get_ticks being non-monotonic"
> - Add a few signed-off-bys which were sent for version 1
> 
> Changes in v2:
> - Fix fls being off-by-one when compared to log_2_n_round_up
> - Move watchdog enable to k210.dtsi as it does not depend on anything
>   board-specific.
> 
> Sean Anderson (7):
>   wdt: dw: Switch to using fls for log2
>   wdt: dw: Switch to if(CONFIG()) instead of using #if
>   wdt: dw: Fix clock rate being off by 1000
>   wdt: dw: Enable the clock before using it
>   wdt: dw: Free the clock on error
>   riscv: Add watchdog bindings for the k210
>   riscv: Enable watchdog for the k210
> 
>  arch/riscv/dts/k210.dtsi          |  1 -
>  board/sipeed/maix/Kconfig         |  2 ++
>  drivers/watchdog/designware_wdt.c | 39 ++++++++++++++++++++-----------
>  3 files changed, 27 insertions(+), 15 deletions(-)
> 

*ping*

Marek can these go into -next?

--Sean


More information about the U-Boot mailing list