[PATCH v4 0/7] wdt: Add support for watchdogs on Kendryte K210

[Sean Anderson]

On 10/1/20 10:56 AM, Sean Anderson wrote:
> On 9/9/20 5:04 PM, Sean Anderson wrote:
>> This series depends on
>> https://patchwork.ozlabs.org/project/uboot/list/?series=200642
>>
>> Changes in v4:
>> - Fix build error without CONFIG_CLK
>>
>> Changes in v3:
>> - Note dependency on "time: Fix get_ticks being non-monotonic"
>> - Add a few signed-off-bys which were sent for version 1
>>
>> Changes in v2:
>> - Fix fls being off-by-one when compared to log_2_n_round_up
>> - Move watchdog enable to k210.dtsi as it does not depend on anything
>>   board-specific.
>>
>> Sean Anderson (7):
>>   wdt: dw: Switch to using fls for log2
>>   wdt: dw: Switch to if(CONFIG()) instead of using #if
>>   wdt: dw: Fix clock rate being off by 1000
>>   wdt: dw: Enable the clock before using it
>>   wdt: dw: Free the clock on error
>>   riscv: Add watchdog bindings for the k210
>>   riscv: Enable watchdog for the k210
>>
>>  arch/riscv/dts/k210.dtsi          |  1 -
>>  board/sipeed/maix/Kconfig         |  2 ++
>>  drivers/watchdog/designware_wdt.c | 39 ++++++++++++++++++++-----------
>>  3 files changed, 27 insertions(+), 15 deletions(-)
>>
> 
> *ping*
> 
> Marek can these go into -next?
> 
> --Sean
> 

*second ping*

It appears that an earlier version of this series [1] was assigned to
Marek Vasut, but that the current version is assigned to Rick Chen. v2
should be marked as superseded. Can this get picked up for the merge
window?

--Sean

[1] https://patchwork.ozlabs.org/project/uboot/list/?series=194673
[2] https://patchwork.ozlabs.org/project/uboot/list/?series=200657