[PATCH 2/3] usb: ehci-mx6: add IMX8MM OTG support

Tim Harvey tharvey at gateworks.com
Tue Apr 27 19:50:34 CEST 2021


On Tue, Apr 27, 2021 at 10:44 AM Marek Vasut <marex at denx.de> wrote:
>
> On 4/27/21 7:08 PM, Tim Harvey wrote:
> > Add support for determining host vs peripheral mode for IMX8MM
> > configured as OTG.
> >
> > Signed-off-by: Tim Harvey <tharvey at gateworks.com>
> > ---
> >   drivers/usb/host/ehci-mx6.c | 2 +-
> >   1 file changed, 1 insertion(+), 1 deletion(-)
> >
> > diff --git a/drivers/usb/host/ehci-mx6.c b/drivers/usb/host/ehci-mx6.c
> > index c2dfe49012..d055d2b1fe 100644
> > --- a/drivers/usb/host/ehci-mx6.c
> > +++ b/drivers/usb/host/ehci-mx6.c
> > @@ -523,7 +523,7 @@ static int ehci_usb_phy_mode(struct udevice *dev)
> >                       plat->init_type = USB_INIT_DEVICE;
> >               else
> >                       plat->init_type = USB_INIT_HOST;
> > -     } else if (is_mx7()) {
> > +     } else if (is_mx7() || is_imx8mm()) {
>
> This likely also applies to 8mq/mm/mn/mp , i.e. all of them.

Agreed. Perhaps Adam, Frieder, or Fabio have something to test with? I
only have IMX8M Mini at the moment.

Tim


More information about the U-Boot mailing list