[PATCH 2/3] usb: ehci-mx6: add IMX8MM OTG support

[Marek Vasut]

On 4/27/21 7:08 PM, Tim Harvey wrote:
> Add support for determining host vs peripheral mode for IMX8MM
> configured as OTG.
> 
> Signed-off-by: Tim Harvey <tharvey at gateworks.com>
> ---
>   drivers/usb/host/ehci-mx6.c | 2 +-
>   1 file changed, 1 insertion(+), 1 deletion(-)
> 
> diff --git a/drivers/usb/host/ehci-mx6.c b/drivers/usb/host/ehci-mx6.c
> index c2dfe49012..d055d2b1fe 100644
> --- a/drivers/usb/host/ehci-mx6.c
> +++ b/drivers/usb/host/ehci-mx6.c
> @@ -523,7 +523,7 @@ static int ehci_usb_phy_mode(struct udevice *dev)
>   			plat->init_type = USB_INIT_DEVICE;
>   		else
>   			plat->init_type = USB_INIT_HOST;
> -	} else if (is_mx7()) {
> +	} else if (is_mx7() || is_imx8mm()) {

This likely also applies to 8mq/mm/mn/mp , i.e. all of them.