[PATCH v1] imx: mkimage_fit_atf: replace @ with hyphen

Heiko Thiery heiko.thiery at gmail.com
Fri Aug 13 17:12:11 CEST 2021


Hi Fabio,

Am Fr., 13. Aug. 2021 um 15:03 Uhr schrieb Fabio Estevam <festevam at gmail.com>:
>
> Hi Heiko,
>
> On Fri, Aug 13, 2021 at 9:53 AM Heiko Thiery <heiko.thiery at gmail.com> wrote:
>
> > Maybe I'm wrong or I do not fully understand the limitation you're
> > talking about, but as far as I understand the output (flash.bin) from
> > the ronetix board [1] was generated using binman and includes all
> > necessary parts. Is this right?
>
> Building the imx8mq_cm_defconfig generates flash.bin + u-boot.itb.
>
> If you only flash flash.bin, then you don't have a bootable system as
> flash.bin contains only the SPL part.
>
> Prior to using binman, we could boot the i.MX8M boards by flashing
> only flash.bin.
>
> I would like to preserver the pre-U-Boot 2021.07, where only flash.bin
> was needed.

I had taken the binman configuration from imx8mq_cm_defconfig and
adapted it for my board (kontron-pitx-imx8m). I had copied the
flash.bin image to my SD card and am of the opinion that this had
started afterwards with the current u-boot. Unfortunately I can test
it only next week again, because I currently have no device at hand.

I must confess that I do not yet fully understand how binman works.

I'll get back to you next week.

-- 
Heiko


More information about the U-Boot mailing list