MX6sabresd broken since v2019.04

[Fabio Estevam]

Hi Marek,

On Mon, Feb 1, 2021 at 8:28 AM Marek Vasut <marex at denx.de> wrote:

> Did you test that yourself? I am CCing Christoph, as I don't have the

Yes, I tested it myself:

U-Boot SPL 2021.01 (Jan 23 2021 - 14:34:35 -0300)
Trying to boot from MMC1


U-Boot 2021.01 (Jan 23 2021 - 14:34:35 -0300)

CPU:   Freescale i.MX6Q rev1.2 996 MHz (running at 792 MHz)
CPU:   Automotive temperature grade (-40C to 125C) at 43C
Reset cause: POR
Model: Freescale i.MX6 Quad SABRE Smart Device Board
I2C:   ready
DRAM:  1 GiB
PMIC:  PFUZE100 ID=0x10
MMC:   FSL_SDHC: 0, FSL_SDHC: 1, FSL_SDHC: 3
Loading Environment from MMC... OK
No panel detected: default to Hannstar-XGA
Display: Hannstar-XGA (1024x768)
In:    serial
Out:   serial
Err:   serial
Net:   eth0: ethernet at 2188000
Hit any key to stop autoboot:  0

> board. The report I am getting is that it does not boot fine on his end
> when writing u-boot-with-spl.imx to SD card at offset 1024B.

I have flashed the SD card by writing SPL at offset 1kB and
u-boot-dtb.img at 69kB.