MX6sabresd broken since v2019.04

[Marek Vasut]

On 2/1/21 12:37 PM, Fabio Estevam wrote:
> Hi Marek,

Hello Fabio,

> On Mon, Feb 1, 2021 at 8:28 AM Marek Vasut <marex at denx.de> wrote:
> 
>> Did you test that yourself? I am CCing Christoph, as I don't have the
> 
> Yes, I tested it myself:
> 
> U-Boot SPL 2021.01 (Jan 23 2021 - 14:34:35 -0300)
> Trying to boot from MMC1
> 
> 
> U-Boot 2021.01 (Jan 23 2021 - 14:34:35 -0300)
> 
> CPU:   Freescale i.MX6Q rev1.2 996 MHz (running at 792 MHz)
> CPU:   Automotive temperature grade (-40C to 125C) at 43C
> Reset cause: POR
> Model: Freescale i.MX6 Quad SABRE Smart Device Board
> I2C:   ready
> DRAM:  1 GiB
> PMIC:  PFUZE100 ID=0x10
> MMC:   FSL_SDHC: 0, FSL_SDHC: 1, FSL_SDHC: 3
> Loading Environment from MMC... OK
> No panel detected: default to Hannstar-XGA
> Display: Hannstar-XGA (1024x768)
> In:    serial
> Out:   serial
> Err:   serial
> Net:   eth0: ethernet at 2188000
> Hit any key to stop autoboot:  0
> 
>> board. The report I am getting is that it does not boot fine on his end
>> when writing u-boot-with-spl.imx to SD card at offset 1024B.
> 
> I have flashed the SD card by writing SPL at offset 1kB and
> u-boot-dtb.img at 69kB.

Then I have to wonder, does it also work if you write 
u-boot-with-spl.imx to the SD card ? If not, then that might be the 
problem .