[PATCH v3 4/7] arm: dts: ls1028a: disable enetc-2 by default

[Ramon Fried]

On Tue, Jun 29, 2021 at 8:55 PM Vladimir Oltean <vladimir.oltean at nxp.com> wrote:
>
> The enetc-2 port is used as DSA master (connected back-to-back to
> mscc_felix_port4). Since the convention is to not enable ports in the
> common SoC dtsi unless they are used on the board, then enable enetc-2
> only when mscc_felix_port4 itself is enabled.
>
> All existing device trees appear to adhere to this rule, so disable
> enetc-2 in the SoC dtsi.
>
> Signed-off-by: Vladimir Oltean <vladimir.oltean at nxp.com>
> ---
> v2->v3: none
> v1->v2: none
>
>  arch/arm/dts/fsl-ls1028a.dtsi | 2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
>
> diff --git a/arch/arm/dts/fsl-ls1028a.dtsi b/arch/arm/dts/fsl-ls1028a.dtsi
> index 21f4ef78a059..50f9b527cde1 100644
> --- a/arch/arm/dts/fsl-ls1028a.dtsi
> +++ b/arch/arm/dts/fsl-ls1028a.dtsi
> @@ -142,7 +142,7 @@
>                 };
>                 enetc2: pci at 0,2 {
>                         reg = <0x000200 0 0 0 0>;
> -                       status = "okay";
> +                       status = "disabled";
>                         phy-mode = "internal";
>
>                         fixed-link {
> --
> 2.25.1
>
Applied to u-boot-net/master, Thanks !
Ramon