[PATCH v3 4/7] arm: dts: ls1028a: disable enetc-2 by default

Vladimir Oltean vladimir.oltean at nxp.com
Tue Jun 29 19:53:14 CEST 2021


The enetc-2 port is used as DSA master (connected back-to-back to
mscc_felix_port4). Since the convention is to not enable ports in the
common SoC dtsi unless they are used on the board, then enable enetc-2
only when mscc_felix_port4 itself is enabled.

All existing device trees appear to adhere to this rule, so disable
enetc-2 in the SoC dtsi.

Signed-off-by: Vladimir Oltean <vladimir.oltean at nxp.com>
---
v2->v3: none
v1->v2: none

 arch/arm/dts/fsl-ls1028a.dtsi | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/arm/dts/fsl-ls1028a.dtsi b/arch/arm/dts/fsl-ls1028a.dtsi
index 21f4ef78a059..50f9b527cde1 100644
--- a/arch/arm/dts/fsl-ls1028a.dtsi
+++ b/arch/arm/dts/fsl-ls1028a.dtsi
@@ -142,7 +142,7 @@
 		};
 		enetc2: pci at 0,2 {
 			reg = <0x000200 0 0 0 0>;
-			status = "okay";
+			status = "disabled";
 			phy-mode = "internal";
 
 			fixed-link {
-- 
2.25.1



More information about the U-Boot mailing list