[PATCH v3 3/7] arm: dts: ls1028a: declare the fixed-link speeds for the internal ENETC ports

[Ramon Fried]

On Tue, Jun 29, 2021 at 8:55 PM Vladimir Oltean <vladimir.oltean at nxp.com> wrote:
>
> To comply with the device tree bindings expectations for an Ethernet
> controller, as well as to simplify the driver code, declare fixed-link
> nodes for the internal ENETC ports (attached to the mscc_felix switch).
>
> Signed-off-by: Vladimir Oltean <vladimir.oltean at nxp.com>
> ---
> v2->v3: none
> v1->v2: none
>
>  arch/arm/dts/fsl-ls1028a.dtsi | 10 ++++++++++
>  1 file changed, 10 insertions(+)
>
> diff --git a/arch/arm/dts/fsl-ls1028a.dtsi b/arch/arm/dts/fsl-ls1028a.dtsi
> index c7c725a4fc84..21f4ef78a059 100644
> --- a/arch/arm/dts/fsl-ls1028a.dtsi
> +++ b/arch/arm/dts/fsl-ls1028a.dtsi
> @@ -144,12 +144,22 @@
>                         reg = <0x000200 0 0 0 0>;
>                         status = "okay";
>                         phy-mode = "internal";
> +
> +                       fixed-link {
> +                               speed = <2500>;
> +                               full-duplex;
> +                       };
>                 };
>                 mdio0: pci at 0,3 {
>                         #address-cells=<0>;
>                         #size-cells=<1>;
>                         reg = <0x000300 0 0 0 0>;
>                         status = "disabled";
> +
> +                       fixed-link {
> +                               speed = <1000>;
> +                               full-duplex;
> +                       };
>                 };
>
>                 mscc_felix: pci at 0,5 {
> --
> 2.25.1
>
Applied to u-boot-net/master, Thanks !
Ramon