[PATCH V3] board: bsh: imx8mn_bsh_smm_s2/s2pro: enable DM_SERIAL

[Michael Nazzareno Trimarchi]

Hi Stefano

On Wed, Apr 20, 2022 at 7:25 PM Ariel D'Alessandro
<ariel.dalessandro at collabora.com> wrote:
>
> Hi Michael,
>
> On 4/18/22 03:53, Michael Trimarchi wrote:
> > Enable DM_SERIAL for both U_Boot and the SPL. The uart4 and its pinmux
> > are already marked with u-boot,dm-spl but we need to move the call to
> > preloader_console_init() after spl_init() to avoid a board hang
> > as dm can't be used until after spl_init().
> >
> > Remove the manual config of the UART pinmux now that it is no longer
> > needed.
> >
> > Signed-off-by: Michael Trimarchi <michael at amarulasolutions.com>
> > Cc: Tim Harvey <tharvey at gateworks.com>
> > Reviewed-by: Fabio Estevam <festevam at denx.de>
>
> Tested-by: Ariel D'Alessandro <ariel.dalessandro at collabora.com>

Can you queue this one too?

Michael


-- 
Michael Nazzareno Trimarchi
Co-Founder & Chief Executive Officer
M. +39 347 913 2170
michael at amarulasolutions.com
__________________________________

Amarula Solutions BV
Joop Geesinkweg 125, 1114 AB, Amsterdam, NL
T. +31 (0)85 111 9172
info at amarulasolutions.com
www.amarulasolutions.com