[PATCH V3] board: bsh: imx8mn_bsh_smm_s2/s2pro: enable DM_SERIAL

[Stefano Babic]

On 21.04.22 14:37, Michael Nazzareno Trimarchi wrote:
> Hi Stefano
> 
> On Wed, Apr 20, 2022 at 7:25 PM Ariel D'Alessandro
> <ariel.dalessandro at collabora.com> wrote:
>>
>> Hi Michael,
>>
>> On 4/18/22 03:53, Michael Trimarchi wrote:
>>> Enable DM_SERIAL for both U_Boot and the SPL. The uart4 and its pinmux
>>> are already marked with u-boot,dm-spl but we need to move the call to
>>> preloader_console_init() after spl_init() to avoid a board hang
>>> as dm can't be used until after spl_init().
>>>
>>> Remove the manual config of the UART pinmux now that it is no longer
>>> needed.
>>>
>>> Signed-off-by: Michael Trimarchi <michael at amarulasolutions.com>
>>> Cc: Tim Harvey <tharvey at gateworks.com>
>>> Reviewed-by: Fabio Estevam <festevam at denx.de>
>>
>> Tested-by: Ariel D'Alessandro <ariel.dalessandro at collabora.com>
> 
> Can you queue this one too?

It is already applied to master-next, CI is running, if no issue are 
reported is merged into -master.

Best regards,
Stefano

> 
> Michael
> 
> 


-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================