[PATCH 2/2] udoo: neo: Do not print the Model information

[Tommaso Merciai]

On Wed, Jan 05, 2022 at 10:10:03PM +0100, Tommaso Merciai wrote:
> On Wed, Jan 05, 2022 at 05:52:23PM -0300, Fabio Estevam wrote:
> > Hi Tommaso,
> > 
> > On Wed, Jan 5, 2022 at 5:47 PM Tommaso Merciai <tomm.merciai at gmail.com> wrote:
> > 
> > > Hi Fabio,
> > > Thanks, I test your patch on basic and extended model. Below some logs
> > > seems all work properly. I hope I helped the cause :)
> > 
> > Yes, thanks a lot!

It's a pleasure, nice team work :)
Tommaso

> > 
> > >  - BASIC log:
> > > -------------------------------------------------------------------------
> > > U-Boot 2022.01-rc4-00034-g19f31e718f-dirty (Jan 05 2022 - 21:38:32 +0100)
> > >
> > > CPU:   Freescale i.MX6SX rev1.2 996 MHz (running at 792 MHz)
> > > CPU:   Extended Commercial temperature grade (-20C to 105C) at 32C
> > > Reset cause: POR
> > > Model: UDOO Neo Basic
> > 
> > I assume you have only applied 1/2 and not 2/2.
> > 
> > With 2/2 applied the Model line should not be printed.
> > 
> > Thanks
> 
> Yes, Fabio. Sorry, I forgot. Below test with 2/2.
> 
> U-Boot 2022.01-rc4-00034-g19f31e718f-dirty (Jan 05 2022 - 22:07:22 +0100)
> 
> CPU:   Freescale i.MX6SX rev1.2 996 MHz (running at 792 MHz)
> CPU:   Extended Commercial temperature grade (-20C to 105C) at 45C
> Reset cause: POR
> Board: UDOO Neo BASIC
> I2C:   ready
> DRAM:  512 MiB
> PMIC:  PFUZE3000 DEV_ID=0x30 REV_ID=0x11
> MMC:   FSL_SDHC: 1, FSL_SDHC: 2
> Loading Environment from MMC... OK
> In:    serial
> Out:   serial
> Err:   serial
> Net:   eth0: ethernet at 2188000
> Hit any key to stop autoboot:  0
> 
> 
> U-Boot 2022.01-rc4-00034-g19f31e718f-dirty (Jan 05 2022 - 22:07:22 +0100)
> 
> CPU:   Freescale i.MX6SX rev1.2 996 MHz (running at 792 MHz)
> CPU:   Extended Commercial temperature grade (-20C to 105C) at 35C
> Reset cause: POR
> Board: UDOO Neo EXTENDED
> I2C:   ready
> DRAM:  1 GiB
> PMIC:  PFUZE3000 DEV_ID=0x30 REV_ID=0x11
> MMC:   FSL_SDHC: 1, FSL_SDHC: 2
> Loading Environment from MMC... OK
> In:    serial
> Out:   serial
> Err:   serial
> Net:
> Error: ethernet at 2188000 address not set.
> No ethernet found.
> 
> Hit any key to stop autoboot:  0
> 
> Thanks,
> Tommaso