[PATCH 3/3] configs: at91: sama5d2_icp: enable QSPI and SF command

[Sergiu Moga]

Add the configurations required for enabling QSPI and the SF command
to allow changes to be made dynamically to serial flash devices from
the command line interface.

Signed-off-by: Sergiu Moga <sergiu.moga at microchip.com>
Reviewed-by: Tudor Ambarus <tudor.ambarus at microchip.com>
---
 configs/sama5d2_icp_mmc_defconfig | 13 +++++++++++++
 1 file changed, 13 insertions(+)

diff --git a/configs/sama5d2_icp_mmc_defconfig b/configs/sama5d2_icp_mmc_defconfig
index bb70c10e25..5598da9a96 100644
--- a/configs/sama5d2_icp_mmc_defconfig
+++ b/configs/sama5d2_icp_mmc_defconfig
@@ -43,6 +43,7 @@ CONFIG_CMD_DM=y
 CONFIG_CMD_GPIO=y
 CONFIG_CMD_I2C=y
 # CONFIG_CMD_LOADS is not set
+CONFIG_CMD_SF_TEST=y
 CONFIG_CMD_MMC=y
 CONFIG_CMD_DHCP=y
 CONFIG_BOOTP_BOOTFILESIZE=y
@@ -71,6 +72,15 @@ CONFIG_SYS_I2C_AT91=y
 CONFIG_I2C_EEPROM=y
 CONFIG_MMC_SDHCI=y
 CONFIG_MMC_SDHCI_ATMEL=y
+CONFIG_DM_SPI_FLASH=y
+CONFIG_SF_DEFAULT_BUS=2
+CONFIG_SF_DEFAULT_SPEED=66000000
+CONFIG_SPI_FLASH_SFDP_SUPPORT=y
+CONFIG_SPI_FLASH_ATMEL=y
+CONFIG_SPI_FLASH_MACRONIX=y
+CONFIG_SPI_FLASH_SPANSION=y
+CONFIG_SPI_FLASH_STMICRO=y
+CONFIG_SPI_FLASH_SST=y
 CONFIG_DM_ETH=y
 CONFIG_MACB=y
 CONFIG_PINCTRL=y
@@ -82,6 +92,9 @@ CONFIG_ATMEL_USART=y
 CONFIG_SYSRESET=y
 CONFIG_SPL_SYSRESET=y
 CONFIG_SYSRESET_AT91=y
+CONFIG_SPI=y
+CONFIG_DM_SPI=y
+CONFIG_ATMEL_QSPI=y
 CONFIG_TIMER=y
 CONFIG_SPL_TIMER=y
 CONFIG_ATMEL_TCB_TIMER=y
-- 
2.25.1