[PATCH v2 4/8] ARM: imx6: Remove CONFIG_FEC_MXC_PHYADDR from DH header

[sbabic at denx.de]

> Use phy address from device tree instead of CONFIG_FEC_MXC_PHYADDR from
> board header. This is required, because the DH picoITX and DRC02 boards
> require different settings than PDK2. The corresponding 'phy-handle'
> device tree properties are already there.
> I tested this change on picoITX and DRC02, but on PDK2 it is untested.
> Reviewed-by: Marek Vasut <marex at denx.de>
> Signed-off-by: Philip Oberfichtner <pro at denx.de>
Applied to u-boot-imx, master, thanks !

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================