[PATCH RFC] pinctrl: add support for HiSilicon HiSTB SoCs

[Yang Xiwen]

On 2/13/2024 12:58 AM, Tom Rini wrote:
> On Tue, Feb 13, 2024 at 12:30:15AM +0800, Yang Xiwen via B4 Relay wrote:
>
>> From: Yang Xiwen <forbidden405 at outlook.com>
>>
>> The first supported SoC is Hi3798MV200.
>>
>> Signed-off-by: Yang Xiwen <forbidden405 at outlook.com>
>> ---
>> This patchset adds support for HiSTB ioconfig module. The module is used
>> to set pins config(e.g. pull-up, pull-down, drive-strength etc..) and
>> pinmux.
>>
>> The first supported chip is Hi3798MV200. Adding support for Hi3798CV200
>> should be also easy.
>>
>> Below is an example of the dts node:
> [snip]
>
> Has this binding already been accepted to the kernel? Thanks.
>
No, I've not wrote the driver for linux yet. That's why it is RFC now. 
But it is expected to be soon. I'm going to finish u-boot part first and 
work on linux kernel later. After that, i can sync linux dts and 
bindings back to u-boot.

-- 
Regards,
Yang Xiwen