[PATCH] initcall: break loop immediately on failure

Caleb Connolly caleb.connolly at linaro.org
Mon Feb 19 19:35:03 CET 2024


The current ordering always results in func pointing to the next
function in the init_sequence. e.g. if fdtdec_setup() fails, ret will
be set to the error code, then func will be updated to point to
initf_malloc(), only then is ret checked and the loop broken. The end
result of this is that the "initcall failed at ..." error will point you
to initf_malloc(), when the error actually occured in fdtdec_setup()!

This can be quite confusing and result in a lot of time wasted debugging
code that has nothing to do with the failure (ask me how I know :P).

Adjust the for loop to check ret immediately after the call and break
early so that func will correctly reference the failed function.

Signed-off-by: Caleb Connolly <caleb.connolly at linaro.org>
---
 lib/initcall.c | 6 ++++--
 1 file changed, 4 insertions(+), 2 deletions(-)

diff --git a/lib/initcall.c b/lib/initcall.c
index ce317af213ab..128242e5ff55 100644
--- a/lib/initcall.c
+++ b/lib/initcall.c
@@ -52,11 +52,11 @@ int initcall_run_list(const init_fnc_t init_sequence[])
 	ulong reloc_ofs = calc_reloc_ofs();
 	const init_fnc_t *ptr;
 	enum event_t type;
 	init_fnc_t func;
-	int ret = 0;
+	int ret;
 
-	for (ptr = init_sequence; func = *ptr, !ret && func; ptr++) {
+	for (ptr = init_sequence; func = *ptr, func; ptr++) {
 		type = initcall_is_event(func);
 
 		if (type) {
 			if (!CONFIG_IS_ENABLED(EVENT))
@@ -70,8 +70,10 @@ int initcall_run_list(const init_fnc_t init_sequence[])
 			debug("initcall: %p\n", (char *)func - reloc_ofs);
 		}
 
 		ret = type ? event_notify_null(type) : func();
+		if (ret)
+			break;
 	}
 
 	if (ret) {
 		if (CONFIG_IS_ENABLED(EVENT)) {
-- 
2.43.1



More information about the U-Boot mailing list