[PATCH v2] configs: Transpeed 8K618-T: Add Transpeed 8K618-T board support

[Nick Alilovic]

This is a Chinese TV box based on Allwinner H618 SoC.

The DRAM parameters were derived from the values found in a firmware update.

Signed-off-by: Nick Alilovic <nickalilovic at gmail.com>
---
This defconfig relies on the synced sun50i-h618-transpeed-8k618-t.dts file.

 configs/transpeed-8k618-t_defconfig | 27 +++++++++++++++++++++++++++
 1 file changed, 27 insertions(+)
 create mode 100644 configs/transpeed-8k618-t_defconfig

diff --git a/configs/transpeed-8k618-t_defconfig b/configs/transpeed-8k618-t_defconfig
new file mode 100644
index 0000000000..020d3974af
--- /dev/null
+++ b/configs/transpeed-8k618-t_defconfig
@@ -0,0 +1,27 @@
+CONFIG_ARM=y
+CONFIG_ARCH_SUNXI=y
+CONFIG_DEFAULT_DEVICE_TREE="sun50i-h618-transpeed-8k618-t"
+CONFIG_SPL=y
+CONFIG_DRAM_SUN50I_H616_DX_ODT=0x03030303
+CONFIG_DRAM_SUN50I_H616_DX_DRI=0x0e0e0e0e
+CONFIG_DRAM_SUN50I_H616_CA_DRI=0x1f12
+CONFIG_DRAM_SUN50I_H616_TPR0=0xc0001002
+CONFIG_DRAM_SUN50I_H616_TPR10=0x2f1107
+CONFIG_DRAM_SUN50I_H616_TPR11=0xddddcccc
+CONFIG_DRAM_SUN50I_H616_TPR12=0xeddc7665
+CONFIG_MACH_SUN50I_H616=y
+CONFIG_SUNXI_DRAM_H616_DDR3_1333=y
+CONFIG_DRAM_CLK=648
+CONFIG_MMC_SUNXI_SLOT_EXTRA=2
+CONFIG_R_I2C_ENABLE=y
+# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
+CONFIG_SPL_I2C=y
+CONFIG_SPL_SYS_I2C_LEGACY=y
+CONFIG_SYS_I2C_MVTWSI=y
+CONFIG_SYS_I2C_SLAVE=0x7f
+CONFIG_SYS_I2C_SPEED=400000
+CONFIG_SUPPORT_EMMC_BOOT=y
+CONFIG_AXP313_POWER=y
+CONFIG_AXP_DCDC3_VOLT=1360
+CONFIG_USB_EHCI_HCD=y
+CONFIG_USB_OHCI_HCD=y
-- 
2.34.1