[PATCH v1 03/10] configs: colibri-imx8x: Enable EFI

[Francesco Dolcini]

From: Francesco Dolcini <francesco.dolcini at toradex.com>

Enable standard EFI support, as required for booting standard aarch64
Linux distribution, following the ARM recommendations for SystemReady
compliance [1].

The RTC used on this board is not currently supported by U-Boot,
therefore it is not enabled at the moment.

Link: https://developer.arm.com/documentation/DUI1101/4-5/Configure-U-Boot-for-SystemReady [1]
Signed-off-by: Francesco Dolcini <francesco.dolcini at toradex.com>
---
 configs/colibri-imx8x_defconfig | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/configs/colibri-imx8x_defconfig b/configs/colibri-imx8x_defconfig
index fd6a6b47fcfc..abca8a96d630 100644
--- a/configs/colibri-imx8x_defconfig
+++ b/configs/colibri-imx8x_defconfig
@@ -19,7 +19,6 @@ CONFIG_IMX_BOOTAUX=y
 CONFIG_SYS_MEMTEST_START=0x88000000
 CONFIG_SYS_MEMTEST_END=0x89000000
 CONFIG_REMAKE_ELF=y
-# CONFIG_EFI_LOADER is not set
 CONFIG_FIT=y
 CONFIG_FIT_VERBOSE=y
 CONFIG_DISTRO_DEFAULTS=y
@@ -36,11 +35,13 @@ CONFIG_BOARD_EARLY_INIT_F=y
 CONFIG_SYS_PROMPT="Colibri iMX8X # "
 CONFIG_CMD_CPU=y
 CONFIG_CMD_ASKENV=y
+CONFIG_CMD_NVEDIT_EFI=y
 CONFIG_CMD_MEMTEST=y
 CONFIG_CMD_CLK=y
 CONFIG_CMD_DM=y
 CONFIG_CMD_FUSE=y
 CONFIG_CMD_GPIO=y
+CONFIG_CMD_GPT=y
 CONFIG_CMD_I2C=y
 CONFIG_CMD_MMC=y
 CONFIG_CMD_CACHE=y
-- 
2.47.3