[PATCH v1 04/10] configs: toradex-smarc-imx8mp: Enable EFI related options

[Francesco Dolcini]

From: Francesco Dolcini <francesco.dolcini at toradex.com>

Enable EFI related options, as suggested for booting standard aarch64
Linux distribution, following the ARM recommendations for SystemReady
compliance [1].

The RTC used on this board is not currently supported by U-Boot,
therefore it is not enabled at the moment.

Link: https://developer.arm.com/documentation/DUI1101/4-5/Configure-U-Boot-for-SystemReady [1]
Signed-off-by: Francesco Dolcini <francesco.dolcini at toradex.com>
---
 configs/toradex-smarc-imx8mp_defconfig | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/configs/toradex-smarc-imx8mp_defconfig b/configs/toradex-smarc-imx8mp_defconfig
index 13a0e5f028b8..c6097af3ebf0 100644
--- a/configs/toradex-smarc-imx8mp_defconfig
+++ b/configs/toradex-smarc-imx8mp_defconfig
@@ -63,6 +63,7 @@ CONFIG_SPL_WATCHDOG=y
 CONFIG_SYS_PROMPT="SMARC iMX8MP # "
 CONFIG_CMD_ASKENV=y
 # CONFIG_CMD_EXPORTENV is not set
+CONFIG_CMD_NVEDIT_EFI=y
 CONFIG_CRC32_VERIFY=y
 CONFIG_CMD_MD5SUM=y
 CONFIG_MD5SUM_VERIFY=y
@@ -70,6 +71,7 @@ CONFIG_CMD_MEMTEST=y
 CONFIG_CMD_CLK=y
 CONFIG_CMD_FUSE=y
 CONFIG_CMD_GPIO=y
+CONFIG_CMD_GPT=y
 CONFIG_CMD_I2C=y
 CONFIG_CMD_MMC=y
 CONFIG_CMD_PCI=y
@@ -83,7 +85,6 @@ CONFIG_CMD_SYSBOOT=y
 CONFIG_CMD_UUID=y
 CONFIG_CMD_REGULATOR=y
 CONFIG_CMD_EXT4_WRITE=y
-# CONFIG_ISO_PARTITION is not set
 # CONFIG_SPL_EFI_PARTITION is not set
 CONFIG_OF_CONTROL=y
 CONFIG_SPL_OF_CONTROL=y
-- 
2.47.3