[PATCH 2/2] gpio: qcom_pmic_gpio: don't reset pull on direction change

[Petr Hodina via B4 Relay]

From: Petr Hodina <petr.hodina at protonmail.com>

Fix for pull-up/pull-down/disable as that's independent of the direction.

Signed-off-by: Petr Hodina <petr.hodina at protonmail.com>
---
 drivers/gpio/qcom_pmic_gpio.c | 6 ------
 1 file changed, 6 deletions(-)

diff --git a/drivers/gpio/qcom_pmic_gpio.c b/drivers/gpio/qcom_pmic_gpio.c
index 71cc76fef2f..e67e138ede2 100644
--- a/drivers/gpio/qcom_pmic_gpio.c
+++ b/drivers/gpio/qcom_pmic_gpio.c
@@ -129,12 +129,6 @@ static int qcom_gpio_set_direction(struct udevice *dev, unsigned int offset,
 
 	_qcom_gpio_set_direction(dev, offset, input, value);
 
-	/* Set the right pull (no pull) */
-	ret = pmic_reg_write(plat->pmic, gpio_base + REG_DIG_PULL_CTL,
-			     REG_DIG_PULL_NO_PU);
-	if (ret < 0)
-		return ret;
-
 	/* Configure output pin drivers if needed */
 	if (!input) {
 		/* Select the VIN - VIN0, pin is input so it doesn't matter */

-- 
2.53.0