[PATCH 2/3] k3-am62-pocketbeagle2: add initial board support

[Robert Nelson]

On Sat, Mar 28, 2026 at 3:18 AM Marko Mäkelä <marko.makela at iki.fi> wrote:
>
> Hi Robert,
>
> Fri, Mar 27, 2026 at 09:15:35PM +0200, Marko Mäkelä wrote:
> [snip]
> >Can you help me enable the USB serial console, first for u-boot and
> >subsequently for the Linux console?
>
> I just found your reply on this topic:
> https://forum.beagleboard.org/t/pocketbeagle2-with-techlab-cape-usb-to-serial/42940
>
> So, I must wire a 3.3V UART to a JST SH 1.0 mm 3 Pin connector and plug
> it in on the opposite side of the USB-C connector.

Side note, here's my ci builder for u-boot.. :
https://github.com/beagleboard/u-boot-pocketbeagle2

For debug, if you have access to them, grab the Raspberry PI debug
cable: https://www.digikey.com/en/products/detail/raspberry-pi/SC0889/17877576
 and they are available globally..

The JST will plug right in..

Regards,

-- 
Robert Nelson
https://rcn-ee.com/