[U-Boot] How !, Adding a New Device to U-Boot.

Wolfgang Denk wd at denx.de
Thu Mar 19 08:09:40 CET 2009


Dear renjith kumar,

In message <a8474bd70903181921p383be5aatcf36a1727f8f3085 at mail.gmail.com> you wrote:
>
> I was wondering , is there any Discussion or document that describe the way
> how I can Add a  new device to u-Boot.

There is the README, and there is the U-Boot home page, especially
http://www.denx.de/wiki/U-Boot/Patches

> For example , I have two sequoa based, Custom design.
> 
> 1) . I have an FPGA Device at the EBC port of EPx in the second design.
> 
> 2) . In a second case, I have an FPGA Device as the PCI card for ppc440EPx.
> (May be ok with Normal PCI Detection, but How to drive it  ? Any standard
> approach).

If this is the only difference, then eventually a single new board
configuration may be sufficient.

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
If the odds are a million to one against something occuring,  chances
are 50-50 it will.


More information about the U-Boot mailing list