[U-Boot] [PATCH V4 6/8] imx: usb: There is no such register

[Stefano Babic]

On 19/04/2012 10:55, Timo Ketola wrote:
> The reference manual of i.MX25 (nor i.MX31) does not define such
> register. This seems to access read only UH2_CAPLENGTH register (if
> CONFIG_MXC_USB_PORT is zero).
> 
> Signed-off-by: Timo Ketola <timo at exertus.fi>
> ---
> 
> Changes in v4:
> - Rewrapped commit message
> 
> Changes in v2:
> - New patch in this series
> 
>  drivers/usb/host/ehci-mxc.c |    2 --
>  1 files changed, 0 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/usb/host/ehci-mxc.c b/drivers/usb/host/ehci-mxc.c
> index 7384580..45cbd18 100644
> --- a/drivers/usb/host/ehci-mxc.c
> +++ b/drivers/usb/host/ehci-mxc.c
> @@ -125,8 +125,6 @@ int ehci_hcd_init(void)
>  	hcor = (struct ehci_hcor *)((uint32_t) hccr +
>  			HC_LENGTH(ehci_readl(&hccr->cr_capbase)));
>  	setbits_le32(&ehci->usbmode, CM_HOST);
> -	setbits_le32(&ehci->control, USB_EN);
> -
>  	__raw_writel(CONFIG_MXC_USB_PORTSC, &ehci->portsc);
>  	mxc_set_usbcontrol(CONFIG_MXC_USB_PORT, CONFIG_MXC_USB_FLAGS);
>  
Acked-by: Stefano Babic <sbabic at denx.de>

Best regards,
Stefano Babic


-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================