[U-Boot] [PATCH V6 - Part 3 - 0/2] SPI flash enhancements: allow default bus and chip-selects

[Stefano Babic]

On 31/01/2012 20:14, Eric Nelson wrote:
> On 01/31/2012 11:11 AM, Mike Frysinger wrote:
>> On Tuesday 31 January 2012 12:52:06 Eric Nelson wrote:
>>> Patch 1 modifies the 'sf' command to allow a default bus and chip-select
>>> to be specified by board headers. This allows a bare 'sf' probe command:
>>>        U-Boot>  sf probe
>>> instead of the more cumbersome usage when a GPIO is tacked onto
>>> the chip-select. Otherwise, this command-line would be needed
>>> to specify GP3:19 on SabreLite:
>>>        U-Boot>  sf probe 0x5300
>>>
>>> Patch 2 provides a description of usage and configuration of
>>> CONFIG_CMD_SF.
>>
>> you can drop these two SF patches from your mx6q series.  i don't want
>> to keep
>> checking to see if you've updated them :p.
>> -mike
> 
> I figured as much, but I can't really test them without the rest of the
> series...

It does not matter - Mike, what do you think if I merge the whole
patchset into u-boot-imx ? Else the mx6qsabrelite board cannot be built
until all patches will be merged by Wolfgang.

Stefano

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================