[U-Boot] [PATCH V6 - Part 3 - 0/2] SPI flash enhancements: allow default bus and chip-selects

[Dirk Behme]

On 01.02.2012 12:30, Stefano Babic wrote:
> On 31/01/2012 20:14, Eric Nelson wrote:
>> On 01/31/2012 11:11 AM, Mike Frysinger wrote:
>>> On Tuesday 31 January 2012 12:52:06 Eric Nelson wrote:
>>>> Patch 1 modifies the 'sf' command to allow a default bus and chip-select
>>>> to be specified by board headers. This allows a bare 'sf' probe command:
>>>>        U-Boot>  sf probe
>>>> instead of the more cumbersome usage when a GPIO is tacked onto
>>>> the chip-select. Otherwise, this command-line would be needed
>>>> to specify GP3:19 on SabreLite:
>>>>        U-Boot>  sf probe 0x5300
>>>>
>>>> Patch 2 provides a description of usage and configuration of
>>>> CONFIG_CMD_SF.
>>> you can drop these two SF patches from your mx6q series.  i don't want
>>> to keep
>>> checking to see if you've updated them :p.
>>> -mike
>> I figured as much, but I can't really test them without the rest of the
>> series...
> 
> It does not matter - Mike, what do you think if I merge the whole
> patchset into u-boot-imx ? Else the mx6qsabrelite board cannot be built
> until all patches will be merged by Wolfgang.

+1

Thanks

Dirk