[U-Boot] [PATCH 1/1] MX5:MX53: support for Freescale MX53LOCO

[Bud Miljkovic]

Hi Stefano,

 

I have cloned yesterday http://git.denx.de/u-boot.git on to my local
machine and from there selected the v2011.12-rc3 tag.  Then I configured
the mx53loco board and successfully build u-boot.imx, copied the image
to a SD card and powered it up.  What I then got on the serial port
terminal was as follows:

 

U-Boot 2011.12-00201-g137703b (Feb 03 2012 - 11:12:00)

 

CPU:   Freescale i.MX53 family rev2.1 at 800 MHz

Reset cause: POR

Board: MX53 LOCO

DRAM:  1 GiB

WARNING: Caches not enabled

MMC:   FSL_SDHC: 0, FSL_SDHC: 1

*** Warning - bad CRC, using default environment

 

In:    serial

Out:   serial

Err:   serial

Net:

 

At this point, having printed Net:  the program hags.

 

I must say that I am a newbie here but I was able to successfully build
and launch the same u-boot.imx image on my i.MX53 Quick Start Board,
having obtained the source tree via: 

wget ftp://ftp.denx.de/pub/u-boot/u-boot-2011.12.tar.bz2.  As per
instructions I also had to apply the following patches:

 

*         0001-mx53loco-enable-ext-support.patch

*         0002-mx53loco-use-part-1.patch

*
0001-net-eth.c-fix-eth_write_hwaddr-to-use-dev-enetaddr-a.patch

 

The patches were obtained via wget
https://raw.github.com/RobertCNelson/Bootloader-Builder//aster/patches/
<https://raw.github.com/RobertCNelson/Bootloader-Builder/aster/patches/>
...

 

 

I also, applied the same patches on the my v2011.12-rc3 tag but the
resulting build .imx image gave the same output (as above)

 

Is it possible that I did not get the correct tag?

 

Any other ideas?

 

Cheers,

Bud Miljkovic