[U-Boot] [PATCH] Add initial support for mx6slevk board

[Vikram Narayanan]

On 4/2/2013 3:45 AM, Fabio Estevam wrote:
> On Mon, Apr 1, 2013 at 2:44 PM, Fabio Estevam <festevam at gmail.com> wrote:
>> On Mon, Apr 1, 2013 at 2:26 PM, Vikram Narayanan <vikram186 at gmail.com> wrote:
>>
>>> Is the above same for all the variants of i.Mx?
>>> Can we put this into a common header file?
>>
>> Ok, I can try to put this into a common location.
>>
>>>> +#define IOMUX_CONFIG_SION 0x10
>>>> +#define NO_MUX_I                0
>>>> +#define NO_PAD_I                0
>>>> +enum {
>>>> +       MX6_PAD_AUD_MCLK__AUDMUX_AUDIO_CLK_OUT                  =
>>>> IOMUX_PAD(0x02A4, 0x004C, 0, 0x0000, 0, 0),
>>>> +       MX6_PAD_AUD_MCLK__PWM4_PWMO                             =
>>>> IOMUX_PAD(0x02A4, 0x004C, 1, 0x0000, 0, 0),
>>>> +       MX6_PAD_AUD_MCLK__ECSPI3_RDY                            =
>>>> IOMUX_PAD(0x02A4, 0x004C, 2, 0x06B4, 0, 0),
>>>> +       MX6_PAD_AUD_MCLK__FEC_MDC                               =
>>>> IOMUX_PAD(0x02A4, 0x004C, 3, 0x0000, 0, 0),
>>>
>>>
>>> Is the mx6slevk using all the pins defined here?
>>
>> No, I put all pins for completion.
>
> I meant completeness, here.
>
>>> If not please take off the unused IOMUX pins so that we don't add dead code.
>>
>> I thought it was common practice to provide the complete IOMUX pin file.
>
> Looking at mx6q_pins.h I see that the IOMUX table is complete, but
> mx6dl_pins.h is not, so just want to get a confirmation  first before
> doing v2.

Please refer the mx6dl discussion here.
http://www.mail-archive.com/u-boot@lists.denx.de/msg94194.html

It was Troy's idea, to include only the necessary pins.

Regards,
Vikram