[U-Boot] [PATCH 4/8] pxa27x_udc: remove call to unimplemented set_GPIO_mode()
Mike Dunn
mikedunn at newsguy.com
Sun Apr 7 18:41:01 CEST 2013
If CONFIG_USB_DEV_PULLUP_GPIO is defined, a link error occurs because the
set_GPIO_mode() helper function is not implemented. This function doesn't do
much except make the code a little more readable, so I just manually coded its
equivalent and removed the prototype from the header file. It is invoked no
where else in the code.
While I was at it, I noticed that two other function prototypes in the same
header file are also neither implemented nor invoked anywhere, so I removed them
as well.
Signed-off-by: Mike Dunn <mikedunn at newsguy.com>
---
arch/arm/include/asm/arch-pxa/hardware.h | 11 -----------
drivers/usb/gadget/pxa27x_udc.c | 4 +++-
2 files changed, 3 insertions(+), 12 deletions(-)
diff --git a/arch/arm/include/asm/arch-pxa/hardware.h b/arch/arm/include/asm/arch-pxa/hardware.h
index 44b800f..2397bce 100644
--- a/arch/arm/include/asm/arch-pxa/hardware.h
+++ b/arch/arm/include/asm/arch-pxa/hardware.h
@@ -77,17 +77,6 @@
#define GPIO_FALLING_EDGE 1
#define GPIO_RISING_EDGE 2
#define GPIO_BOTH_EDGES 3
-extern void set_GPIO_IRQ_edge( int gpio_nr, int edge_mask );
-
-/*
- * Handy routine to set GPIO alternate functions
- */
-extern void set_GPIO_mode( int gpio_mode );
-
-/*
- * return current lclk frequency in units of 10kHz
- */
-extern unsigned int get_lclk_frequency_10khz(void);
#endif
diff --git a/drivers/usb/gadget/pxa27x_udc.c b/drivers/usb/gadget/pxa27x_udc.c
index 4c00081..71cc0f2 100644
--- a/drivers/usb/gadget/pxa27x_udc.c
+++ b/drivers/usb/gadget/pxa27x_udc.c
@@ -610,7 +610,9 @@ void udc_connect(void)
#ifdef CONFIG_USB_DEV_PULLUP_GPIO
/* Turn on the USB connection by enabling the pullup resistor */
- set_GPIO_mode(CONFIG_USB_DEV_PULLUP_GPIO | GPIO_OUT);
+ writel(readl(GPDR(CONFIG_USB_DEV_PULLUP_GPIO))
+ | GPIO_bit(CONFIG_USB_DEV_PULLUP_GPIO),
+ GPDR(CONFIG_USB_DEV_PULLUP_GPIO));
writel(GPIO_bit(CONFIG_USB_DEV_PULLUP_GPIO), GPSR(CONFIG_USB_DEV_PULLUP_GPIO));
#else
/* Host port 2 transceiver D+ pull up enable */
--
1.7.8.6
More information about the U-Boot
mailing list