[U-Boot] How do I use AM335x eth1 rather than eth0 ?
Mark Jackson
mpfj-list at mimc.co.uk
Fri Apr 12 12:32:06 CEST 2013
We have a dual Ethernet board (based on the BeagelBone) but with both Ethernet ports connected.
I'm wanting to use eth1 (rather than eth0), so in my board.c file, I changed:-
static struct cpsw_slave_data cpsw_slaves[] = {
{
.slave_reg_ofs = 0x208,
.sliver_reg_ofs = 0xd80,
.phy_id = 0,
},
{
.slave_reg_ofs = 0x308,
.sliver_reg_ofs = 0xdc0,
.phy_id = 1,
},
};
... to ...
static struct cpsw_slave_data cpsw_slaves[] = {
{
.slave_reg_ofs = 0x308,
.sliver_reg_ofs = 0xdc0,
.phy_id = 1,
},
{
.slave_reg_ofs = 0x208,
.sliver_reg_ofs = 0xd80,
.phy_id = 0,
},
};
... assuming that eth0 would now be ignored (as only 1 slave is configured).
But (eg) dhcp still only responds on eth0 !?!
What else do I have to change ?
Cheers
Mark J.
More information about the U-Boot
mailing list