[U-Boot] [PATCH 2/3] wandboard: Add support for carrier board MicroSD card

Otavio Salvador otavio at ossystems.com.br
Mon Apr 15 16:06:38 CEST 2013


On Mon, Apr 15, 2013 at 10:54 AM, Fabio Estevam <festevam at gmail.com> wrote:
> On Mon, Apr 15, 2013 at 10:35 AM, Otavio Salvador
> <otavio at ossystems.com.br> wrote:
>
>>  int board_mmc_init(bd_t *bis)
>>  {
>> -       imx_iomux_v3_setup_multiple_pads(usdhc3_pads, ARRAY_SIZE(usdhc3_pads));
>> -
>> -       usdhc_cfg[0].sdhc_clk = mxc_get_clock(MXC_ESDHC3_CLK);
>> -       usdhc_cfg[0].max_bus_width = 4;
>> -       gpio_direction_input(USDHC3_CD_GPIO);
>> +       int i;
>> +
>> +       /*
>> +        * According to the board_mmc_init() the following map is done:
>> +        * (U-boot device node)    (Physical Port)
>> +        * mmc0                    SOM MicroSD
>> +        * mmc1                    Carrier board MicroSD
>> +        */
>> +       for (i = 0; i < CONFIG_SYS_FSL_USDHC_NUM; i++) {
>> +               switch (i) {
>> +               case 0:
>> +                       imx_iomux_v3_setup_multiple_pads(
>> +                               usdhc3_pads, ARRAY_SIZE(usdhc3_pads));
>> +                       usdhc_cfg[0].sdhc_clk = mxc_get_clock(MXC_ESDHC3_CLK);
>> +                       usdhc_cfg[0].max_bus_width = 4;
>> +                       gpio_direction_input(USDHC3_CD_GPIO);
>> +                       break;
>> +               case 1:
>> +                       imx_iomux_v3_setup_multiple_pads(
>> +                               usdhc1_pads, ARRAY_SIZE(usdhc1_pads));
>> +                       usdhc_cfg[1].sdhc_clk = mxc_get_clock(MXC_ESDHC_CLK);
>> +                       usdhc_cfg[1].max_bus_width = 4;
>> +                       gpio_direction_input(USDHC1_CD_GPIO);
>> +                       break;
>> +               default:
>> +                       printf("Warning: you configured more USDHC controllers"
>> +                                  "(%d) than supported by the board\n", i + 1);
>> +                       return 0;
>
> This should be an error. What about return -EINVAL ?

Agreed, fixed locally.

>> +               }
>> +
>> +               if (fsl_esdhc_initialize(bis, &usdhc_cfg[i]))
>> +                       printf("Warning: failed to initialize mmc dev %d\n", i);
>> +       }
>>
>> -       return fsl_esdhc_initialize(bis, &usdhc_cfg[0]);
>> +       return 0;
>
> With this change, you never return an error.

Should we fail if *any* fail?

--
Otavio Salvador                             O.S. Systems
E-mail: otavio at ossystems.com.br  http://www.ossystems.com.br
Mobile: +55 53 9981-7854              http://projetos.ossystems.com.br


More information about the U-Boot mailing list