[U-Boot] [PATCH 3/9] mx23evk: Fix DDR pin iomux settings

[Fabio Estevam]

From: Fabio Estevam <fabio.estevam at freescale.com>

Registers HW_PINCTRL_DRIVE9, HW_PINCTRL_DRIVE10, HW_PINCTRL_DRIVE11,
HW_PINCTRL_DRIVE12, HW_PINCTRL_DRIVE13 and HW_PINCTRL_DRIVE14 control the drive
strength and the voltage selection for the DDR pins.

The reset values of the voltage selection pins are '1', which is marked as
'reserved' in the mx23 reference manual.

Clear these bits for proper operation of DDR.

Also change MUX_CONFIG_EMI, which results in better stability and match the
bootlets code from Freescale.

Signed-off-by: Fabio Estevam <fabio.estevam at freescale.com>
---
 board/freescale/mx23evk/spl_boot.c |   12 +++++++++++-
 1 file changed, 11 insertions(+), 1 deletion(-)

diff --git a/board/freescale/mx23evk/spl_boot.c b/board/freescale/mx23evk/spl_boot.c
index b6f4e7e..035a29c 100644
--- a/board/freescale/mx23evk/spl_boot.c
+++ b/board/freescale/mx23evk/spl_boot.c
@@ -26,7 +26,7 @@
 #include <asm/arch/sys_proto.h>
 
 #define	MUX_CONFIG_SSP1	(MXS_PAD_3V3 | MXS_PAD_8MA | MXS_PAD_PULLUP)
-#define	MUX_CONFIG_EMI	(MXS_PAD_3V3 | MXS_PAD_16MA | MXS_PAD_PULLUP)
+#define	MUX_CONFIG_EMI	MXS_PAD_12MA
 
 const iomux_cfg_t iomux_setup[] = {
 	/* DUART */
@@ -110,5 +110,15 @@ void mxs_adjust_memory_params(uint32_t *dram_vals)
 
 void board_init_ll(void)
 {
+	struct mxs_pinctrl_regs *pinctrl =
+		(struct mxs_pinctrl_regs *)MXS_PINCTRL_BASE;
+	/* Clear the voltage bits for EMI pins as the reset value is invalid */
+	writel(0, &pinctrl->drive9);
+	writel(0, &pinctrl->drive10);
+	writel(0, &pinctrl->drive11);
+	writel(0, &pinctrl->drive12);
+	writel(0, &pinctrl->drive13);
+	writel(0, &pinctrl->drive14);
+	writel(0, &pinctrl->drive9);
 	mxs_common_spl_init(iomux_setup, ARRAY_SIZE(iomux_setup));
 }
-- 
1.7.9.5