[U-Boot] [PATCH 2/3] mx23evk: Do not set voltage selection bit for SSP pads

Marek Vasut marex at denx.de
Mon May 6 04:29:15 CEST 2013


Dear Fabio Estevam,

> On Sun, May 5, 2013 at 11:20 PM, Marek Vasut <marex at denx.de> wrote:
> > Dear Fabio Estevam,
> > 
> >> From: Fabio Estevam <fabio.estevam at freescale.com>
> >> 
> >> mx23 SSP pad registers do not contain voltage selection bit, so just
> >> remove it.
> >> 
> >> Signed-off-by: Fabio Estevam <fabio.estevam at freescale.com>
> > 
> > None of them do, so you can wipe those altogether for all the #defines,
> > no ?
> 
> Sorry, I cannot understand this comment.

None of the MX23 pins contain voltage selection bit, you can just remove them 
all.

Best regards,
Marek Vasut


More information about the U-Boot mailing list