[U-Boot] [PATCH v3 0/16] Provide a mechanism to avoid using #ifdef everywhere

[Simon Glass]

Hi Tom,

On Thu, May 16, 2013 at 9:26 AM, Tom Rini <trini at ti.com> wrote:
> On Wed, May 15, 2013 at 07:13:18AM -0700, Simon Glass wrote:
>
> [snip]
>> I've brought over the patches that I can that don't depend on autoconf:
>>
>> 6c0e6c9 (HEAD, ws/us-config5, us-config5) main: Add debug_bootkeys to
>> avoid #ifdefs
>> 9777b9f main: Add debug_parser() to avoid #ifdefs
>> 2fc85b6 main: Correct header order
>> 24e80be main: Fix typos and checkpatch warnings in command line reading
>> 9e9e3b9 main: Use get/setenv_ulong()
>> 1290cb7 main: Move boot_delay code into its own function
>> cd8f13e main: Separate out the two abortboot() functions
>> ca2451c net: Add prototype for update_tftp
>> 4a2a802 at91: Correct CONFIG_AUTOBOOT_PROMPT definition for pm9263
>>
>> I will run these through the builder and send an interim series
>> without autoconf. We still have a lot of inline #ifdefs, and static
>> functions and local variables must also be #ifdefed out if not used.
>> Still, there is some improvement.
>
> I've read them over and they look good.  Since you didn't re-send
> anything I assume they passed your builder test and I'll apply them next
> week (and give them my own builder test like everything else gets).
> Thanks!

Yes I did a full build and saw no additional failures from my patch.
But then I did a few whitespace changes and only built a few boards
after that. I think it's OK though.

Regards,
Simon