[U-Boot] [PATCH v3 07/10] net: pcnet: use pci_virt_to_mem to obtain buffer addresses

Gabor Juhos juhosg at openwrt.org
Wed May 22 15:57:43 CEST 2013


The pcnet driver uses the pci_phys_to_mem function
to get the memory address of the DMA buffers. This
This assumes an 1:1 mapping between the PCI and
physical memory which is not true on all platforms.

On MIPS platform U-Boot is running within a mapped
memory region, and the pci_phys_to_mem macro can't
be used to obtain the memory address of the buffers.

Signed-off-by: Gabor Juhos <juhosg at openwrt.org>
Cc: Daniel Schwierzeck <daniel.schwierzeck at googlemail.com>
---
Changes since v2:
  - rebased against the master branch of git.denx.de/u-boot.git

Changes since v1:
 - rebased against mips/testing

Changes since RFC: ---

---
Note:

This is only tested with the qemu-malta target. The change
might break real platforms, however I have no suitable board
to test it.

-Gabor
---
 drivers/net/pcnet.c |    2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/net/pcnet.c b/drivers/net/pcnet.c
index c028a44..45a66fb 100644
--- a/drivers/net/pcnet.c
+++ b/drivers/net/pcnet.c
@@ -146,7 +146,7 @@ static int pcnet_recv (struct eth_device *dev);
 static void pcnet_halt (struct eth_device *dev);
 static int pcnet_probe (struct eth_device *dev, bd_t * bis, int dev_num);
 
-#define PCI_TO_MEM(d,a) pci_phys_to_mem((pci_dev_t)d->priv, (u_long)(a))
+#define PCI_TO_MEM(d, a) pci_virt_to_mem((pci_dev_t)d->priv, (a))
 #define PCI_TO_MEM_LE(d,a) (u32)(cpu_to_le32(PCI_TO_MEM(d,a)))
 
 static struct pci_device_id supported[] = {
-- 
1.7.10



More information about the U-Boot mailing list