[U-Boot] [PATCH 2/2] mx6: Adjust the GPR offset for mx6solox

[Stefano Babic]

On 09/07/2014 22:59, Fabio Estevam wrote:
> From: Fabio Estevam <fabio.estevam at freescale.com>
> 
> On mx6solox there is an additional 0x4000 offset for the GPR registers.
> 
> Signed-off-by: Fabio Estevam <fabio.estevam at freescale.com>
> ---


Applied to u-boot-imx, thanks !

Best regards,
Stefano Babic


-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================