[U-Boot] [PATCH 2/2] mx6: Adjust the GPR offset for mx6solox
Stefano Babic
sbabic at denx.de
Fri Jul 11 09:42:02 CEST 2014
Hi Fabio,
On 09/07/2014 22:59, Fabio Estevam wrote:
> From: Fabio Estevam <fabio.estevam at freescale.com>
>
> On mx6solox there is an additional 0x4000 offset for the GPR registers.
>
> Signed-off-by: Fabio Estevam <fabio.estevam at freescale.com>
> ---
> This applies against 'next' branch.
>
> arch/arm/include/asm/arch-mx6/imx-regs.h | 3 +++
> 1 file changed, 3 insertions(+)
>
> diff --git a/arch/arm/include/asm/arch-mx6/imx-regs.h b/arch/arm/include/asm/arch-mx6/imx-regs.h
> index 782d9c4..cc746b8 100644
> --- a/arch/arm/include/asm/arch-mx6/imx-regs.h
> +++ b/arch/arm/include/asm/arch-mx6/imx-regs.h
> @@ -398,6 +398,9 @@ struct src {
>
>
> struct iomuxc {
> +#ifdef CONFIG_MX6SX
> + u8 reserved[0x4000];
> +#endif
> u32 gpr[14];
> u32 omux[5];
> /* mux and pad registers */
>
Acked-by: Stefano Babic <sbabic at denx.de>
Best regards,
Stefano Babic
--
=====================================================================
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================
More information about the U-Boot
mailing list