[U-Boot] U-Boot stuck after relocation attempt on MX51 board

[DaveKucharczyk]

Fabio Estevam-2 wrote
> Also, you said that your 512MB board version works fine, but the 256MB
> fails.
> 
> I suppose you are using two different binaries for each board, right?
> You can't have a single binary for the two boards, unless you use the
> SPL approach.

Fabio, we use one binary. It has runtime memory discovery via gpio's
(resistor reads). DRAM size is reported correctly from both boards. It just
hangs on the 256MB board. 

We do not have SPL setup.  




--
View this message in context: http://u-boot.10912.n7.nabble.com/U-Boot-stuck-after-relocation-attempt-on-MX51-board-tp206738p206862.html
Sent from the U-Boot mailing list archive at Nabble.com.