[U-Boot] [PATCH] ddr: altera: silence PHY calibration unless in debug mode

[Marek Vasut]

On 01/11/2018 08:19 AM, Goldschmidt Simon wrote:
> This driver has been using printf() including filename since it was
> added. Convert to using debug() instead.
> 
> Signed-off-by: Simon Goldschmidt <sgoldschmidt at de.pepperl-fuchs.com>

Applied, thanks.

> ---
> 
>  drivers/ddr/altera/sequencer.c | 8 ++++----
>  1 file changed, 4 insertions(+), 4 deletions(-)
> 
> diff --git a/drivers/ddr/altera/sequencer.c b/drivers/ddr/altera/sequencer.c
> index 6c6bd90e94..42e87b50d3 100644
> --- a/drivers/ddr/altera/sequencer.c
> +++ b/drivers/ddr/altera/sequencer.c
> @@ -3534,7 +3534,7 @@ static void debug_mem_calibrate(int pass)
>  	u32 debug_info;
>  
>  	if (pass) {
> -		printf("%s: CALIBRATION PASSED\n", __FILE__);
> +		debug("%s: CALIBRATION PASSED\n", __FILE__);
>  
>  		gbl->fom_in /= 2;
>  		gbl->fom_out /= 2;
> @@ -3553,7 +3553,7 @@ static void debug_mem_calibrate(int pass)
>  		writel(debug_info, &phy_mgr_cfg->cal_debug_info);
>  		writel(PHY_MGR_CAL_SUCCESS, &phy_mgr_cfg->cal_status);
>  	} else {
> -		printf("%s: CALIBRATION FAILED\n", __FILE__);
> +		debug("%s: CALIBRATION FAILED\n", __FILE__);
>  
>  		debug_info = gbl->error_stage;
>  		debug_info |= gbl->error_substage << 8;
> @@ -3570,7 +3570,7 @@ static void debug_mem_calibrate(int pass)
>  		writel(debug_info, &sdr_reg_file->failing_stage);
>  	}
>  
> -	printf("%s: Calibration complete\n", __FILE__);
> +	debug("%s: Calibration complete\n", __FILE__);
>  }
>  
>  /**
> @@ -3741,7 +3741,7 @@ int sdram_calibration_full(void)
>  
>  	initialize_tracking();
>  
> -	printf("%s: Preparing to start memory calibration\n", __FILE__);
> +	debug("%s: Preparing to start memory calibration\n", __FILE__);
>  
>  	debug("%s:%d\n", __func__, __LINE__);
>  	debug_cond(DLEVEL >= 1,
> 


-- 
Best regards,
Marek Vasut