[U-Boot] [PATCH] ddr: altera: silence PHY calibration unless in debug mode

[Goldschmidt Simon]

On 01/11/2018 12:28, Marek Vasut wrote:
> On 01/11/2018 08:19 AM, Goldschmidt Simon wrote:
>> This driver has been using printf() including filename since it was
>> added. Convert to using debug() instead.
>>
>> Signed-off-by: Simon Goldschmidt <sgoldschmidt at de.pepperl-fuchs.com>
> 
> Applied, thanks.

I can't see this one in u-boot-socfpga. Anything wrong here?

Regards,
Simon

>> ---
>>
>>  drivers/ddr/altera/sequencer.c | 8 ++++----
>>  1 file changed, 4 insertions(+), 4 deletions(-)
>>
>> diff --git a/drivers/ddr/altera/sequencer.c b/drivers/ddr/altera/sequencer.c
>> index 6c6bd90e94..42e87b50d3 100644
>> --- a/drivers/ddr/altera/sequencer.c
>> +++ b/drivers/ddr/altera/sequencer.c
>> @@ -3534,7 +3534,7 @@ static void debug_mem_calibrate(int pass)
>>       u32 debug_info;
>>
>>       if (pass) {
>> -             printf("%s: CALIBRATION PASSED\n", __FILE__);
>> +             debug("%s: CALIBRATION PASSED\n", __FILE__);
>>
>>               gbl->fom_in /= 2;
>>               gbl->fom_out /= 2;
>> @@ -3553,7 +3553,7 @@ static void debug_mem_calibrate(int pass)
>>               writel(debug_info, &phy_mgr_cfg->cal_debug_info);
>>               writel(PHY_MGR_CAL_SUCCESS, &phy_mgr_cfg->cal_status);
>>       } else {
>> -             printf("%s: CALIBRATION FAILED\n", __FILE__);
>> +             debug("%s: CALIBRATION FAILED\n", __FILE__);
<>
>>               debug_info = gbl->error_stage;
>>               debug_info |= gbl->error_substage << 8;
>> @@ -3570,7 +3570,7 @@ static void debug_mem_calibrate(int pass)
>>               writel(debug_info, &sdr_reg_file->failing_stage);
>>       }
>>
>> -     printf("%s: Calibration complete\n", __FILE__);
>> +     debug("%s: Calibration complete\n", __FILE__);
>>  }
>>
>>  /**
>> @@ -3741,7 +3741,7 @@ int sdram_calibration_full(void)
>>
>>       initialize_tracking();
>>
>> -     printf("%s: Preparing to start memory calibration\n", __FILE__);
>> +     debug("%s: Preparing to start memory calibration\n", __FILE__);
>>
>>       debug("%s:%d\n", __func__, __LINE__);
>>       debug_cond(DLEVEL >= 1,
>>
> 
>