[U-Boot] [PATCH v1 18/26] colibri imx6: disable ri and dcd irq in uarts

[Marcel Ziswiler]

From: Max Krummenacher <max.krummenacher at toradex.com>

If the UART is used in DTE mode the RI and DCD bits in UCR3 become
irq enable bits. Both are set to enabled after reset and both likely
are pending.

Disable the bits also on UARTs not used in the boot loader to prevent
an interrupt storm when Linux enables the UART interrupts.

Signed-off-by: Max Krummenacher <max.krummenacher at toradex.com>
Acked-by: Marcel Ziswiler <marcel.ziswiler at toradex.com>

---

 board/toradex/colibri_imx6/colibri_imx6.c | 9 ++++++++-
 1 file changed, 8 insertions(+), 1 deletion(-)

diff --git a/board/toradex/colibri_imx6/colibri_imx6.c b/board/toradex/colibri_imx6/colibri_imx6.c
index 3d72a315b4..76b776e17e 100644
--- a/board/toradex/colibri_imx6/colibri_imx6.c
+++ b/board/toradex/colibri_imx6/colibri_imx6.c
@@ -271,14 +271,21 @@ iomux_v3_cfg_t const usb_pads[] = {
  * UARTs are used in DTE mode, switch the mode on all UARTs before
  * any pinmuxing connects a (DCE) output to a transceiver output.
  */
+#define UCR3		0x88	/* FIFO Control Register */
+#define UCR3_RI		BIT(8)	/* RIDELT DTE mode */
+#define UCR3_DCD	BIT(9)	/* DCDDELT DTE mode */
 #define UFCR		0x90	/* FIFO Control Register */
-#define UFCR_DCEDTE	(1<<6)	/* DCE=0 */
+#define UFCR_DCEDTE	BIT(6)	/* DCE=0 */
 
 static void setup_dtemode_uart(void)
 {
 	setbits_le32((u32 *)(UART1_BASE + UFCR), UFCR_DCEDTE);
 	setbits_le32((u32 *)(UART2_BASE + UFCR), UFCR_DCEDTE);
 	setbits_le32((u32 *)(UART3_BASE + UFCR), UFCR_DCEDTE);
+
+	clrbits_le32((u32 *)(UART1_BASE + UCR3), UCR3_DCD | UCR3_RI);
+	clrbits_le32((u32 *)(UART2_BASE + UCR3), UCR3_DCD | UCR3_RI);
+	clrbits_le32((u32 *)(UART3_BASE + UCR3), UCR3_DCD | UCR3_RI);
 }
 
 static void setup_iomux_uart(void)
-- 
2.20.1